FAQs

  • Q:Will the YJ cup holder fit my YJ Jeep?
  • A:  YJ Cup holders fit all Jeep Wrangler YJ models (1987-1995)
  • Q: Will the CJ cup holder fit my CJ Jeep?
  • A: Only if you DO NOT have the dash pad.   Message us and we can help confirm fitment.
  • Q: Will the cup holder fit with the doors on?
  • A: Yes!  Half doors and Full doors can close properly.  Some models of sliding uppers (on half doors) may interfere.  Pleas reach out to us via email so we can talk about your Jeep.
  • Q: What are these made of?  Are they stainless?
  • A: Mild steel.  They should be protected to ensure they do not rust
    • Q: Will this fit my coffee/beverage cup?
    • A: Most likely.  The opening size in 3.3" in diameter and can fit drink containers as large as a 32oz Yeti tumbler.  Smaller drinks may need to be slide into a coozie for stability.  Message us if you still have questions.
    • Q: Can you do a custom one for my Jeep?
    • A: Yes!  Message us and we can discuss your project.
    • Q: Do you offer volume discounts if I need a lot of cup holders?
    • A: Yes!  Message us.
    • Q: Do I need to make any modifications to install these?
    • A: No.  The cup holders bolt in using the two existing windshield bolts.
    • Q: Do you ship internationally? 
    • A: Yes!!!  Your actual shipping cost will be calculated when you enter your shipping address at checkout.  If you have any problems please reach out to us.
      • Q: Do you offer a military discount?
      • A: Yes!  We are happy to offer a special discount on a pair of YJ or CJ cup holders.  Please reach out to us directly via email so we can provide you with the discount code.
      • Q: I just purchased the Dash Accessory Mount (DAM).  How can I mount my phone or other devices?
      • A: You just need to pick a mount system that is compatible with a ball base (20mm) that has a male 1/4-20 screw.  A 1/4-20 male screw will work with the two drop-in t-nuts that are provided with the DAM.  Some examples are:
        • Tackform:  This or this could be perfect options since they allow you to use a 1/4-20 screw . 
        • RAM: This ball base has the male 1/4-20 screw required. 
        • Bullet Point: This 20mm ball base has the 1/4-20 screw at the bottom.  In the photos on the website you can see my whole phone mount setup which is from bullet point (phone holder and arm).  Bullet point has a GoPro mount, that works with a 20mm ball base.